Hair Chart & Instructions

Products:

-       Tresemme Hair spray

-       Gel

-       Dax

-       Vita Point

Equipment:

-       Curling Tongs

-       Sliver Clips

-       Section Clips

-       Blonde Bobbie Pins

-       Blonde bun pins

-       Blonde Hair band

-       Pin Tail comb

-       Soft Brush

-       Paddle brush

Instructions:

Preparation:

Step 1: Section the from behind the ears to the front and across the crown at the centre back of the head, Clip the back section out of the way. Section a 1 or 2 centimetre section away from the front of the hair to leave to kiss curl- pin or hair band out of the way.

Step 2: wet down the front sections of hair and apply the wet gel all over the section, not too much but enough to give a strong hold. Pulling the hair backwards, clamp the hair with your middle finger then pull the hair forward flick the comb into the hair and push up to create an edge pinch this together with you pointer finger and brush the hair in the opposite direction again- apply sliver long clips to hold the shape you created with your fingers repeat till on the right hand side there are 3 or 4 waves and on the left 1 or 2. Brush the hair back behind the ears and leave to dry- applying section clips to the top of each wave to create more definition if necessary. Using a hair dryer on hot and then cool dry the wet hair.

Step 3: Curl the end sections of all the remaining hair from the back and sides and pin to leave to cool.

Assessment:

Step 1: After prepping the hair and doing the initial foundation base. Begin to section the front section of hair into 5 kiss curls on the right and 3 on the left. Take the section of hair and apply Dax or gel to the canter of the hand massaging into the hair- make sure not too much as this will create the hair to be very heavy. Take a kiss curl section and wrap it around you finger pull it off gently and stick onto the face applying Hair spray until stuck (make sure the curl is secure before moving onto the next) repeat until done.

Step 3: unclipping the curls done previously at the bottom of the sections pull the back section of the hair tight onto the head creating tension pull into a tight pony tail at the nape of the neck. Hair spray and smooth with soft brush if needed. Taking the finger wave sections and leaving the clips in pin at each side of the pony tail again pulling flat against the head.

Step 4: Creating the pin curls at the nape of the neck, take each section hair from either the pony tail or the pinned finger wave section and brush with the softer brush manipulating into a curl twist up using your fingers and pin close to the head hiding all pins use bun pins if extra pins are needed to secure. Create 4 pin curls two central and 2 either side behind the ears.

Step 5: Remove the finger wave clips when set applying lots of hair spray to finish.